Skip Ribbon Commands Skip to main content
Hurco Motion Control

UltiMotion Reduces Cycle Time + Improves Surface Finish

Request Information
WinMax Free Trial

Overview


Surface Finish

improve-surface-finish.jpg
The engineering team at Hurco refers to UltiMotion as soft motion because the software controls the motion control system versus a conventional motion control that relies on hardware. The software is more efficient in how it processes the motion so there is less chatter, less vibration, less machine jerk, which results in better surface finish.

Cycle Time

reduce-cycle-time.jpgThe secret to UltiMotion is the advanced algorithm software that takes the load off the motion control board (hardware-based motion control). The software-based motion control system of UltiMotion has rapid cornering capabilities, which means it doesn’t stop between two rapids. Instead, it travels through blended corners at high speed with negligible deviation. With UltiMotion, the software evaluates each section of the motion profile and shifts the look-ahead to the maximum number of blocks to optimize maneuvers.

Drill/Tap

faster-drilling-quality-tapping.jpg
Because UltiMotion uses advanced software algorithm for motion control, it is able to move faster in every way. For example, with drilling and tapping, instead of the jolting down/up/stop motion of conventional motion controls system’s that use hardware, UltiMotion keeps the motion smooth and is able to use a spherical motion to move to the next set of holes.

Extend Machine Life

extend-machine-life.jpg
While we have not conducted a longitudinal study, common sense dictates that smoother motion of the machining process puts less stress on the ball screw and other internal components. Machining with less chatter, less vibration, and less machine jerk, retains accuracy and may extend the life of the machine.


Customer Talks UltiMotion

 “We are builders of custom orthotics. We are not machinists. We focus on throughput and speed. With UltiMotion we’re seeing 30-35% faster throughput,”

 — Tom Miller, M-Tech.
 Read more

Tom-Miller-M-Tech-owner.jpg


Top