Skip Ribbon Commands Skip to main content

MY X AXIS ON MY HURCO AB7 AUTOBEND CONTROL IS NOT MOVING  

This article applies to:
Autobend Backgauges
Autobend 7 Control 
Metal Fabrication 
Autobend Controls 

Answer:
My X Axis is not moving on my Hurco AB7 Autobend Control.
Try the following steps:
Make sure that the motion module and main board are seated together
Check to see that the green run light on the Copley amp. lights up when the run button is pushed.
Check the dac, servo enable and the input voltage (47 or 63 vdc) on the Copley amp.
Make sure that the connections on the motor and tach are secure.
Move the backgauge by hand to see if you have any mechanical binding.
Check for an opening winding on the motor (1 ohm), and tach (47ohm).
Check for motor output (3-5vdc), and tach (2-3vdc) when moving the backgauge hand.
If the problem persists, contact Hurco Technical Support for additional information.

 
 
Bookmark this post with: