Skip Ribbon Commands Skip to main content

MY AB7 HURCO AUTOBEND CONTROL IS REPORTING A "MOTION ERROR"  

This article applies to:
Autobend Controls 
Autobend 7 Control 

Answer:
ITEMS TO CHECK:
Does the backguage move?
Check for mechanical binding on the ballscrew.
Check encoder for proper operation.
Check to make sure you are getting 2-63vdc at the motor when the run button is pressed.
Does the green run light on the Copley Amp come on when the run button is pressed?
If the problem persists, contact Hurco Technical Support for further assistance.

 
 
Bookmark this post with: